I'm looking for solution to downgrade from 5.0 to 4.5 .Any info will be very helpful.
I'm looking for solution to downgrade from 5.0 to 4.5 .Any info will be very helpful.
Need a dump LC4064V.
Thanks in advance!
Does this (attached) version can read the locked MCU MC68HC05B16?
what is xprog?
enigmaelectroni (30th March, 2021)
Many people ask me this question:
"How do I program XPROG-m, another programmer XPROG-m".
Below is a solution.
albonidao (11th February, 2019), amir_82013 (11th June, 2014), boxsport (27th September, 2019), ecufix (25th July, 2019), jason1000 (27th July, 2017), jorgesecurity (8th October, 2020), line44 (24th March, 2021), maremuruk (16th March, 2017), tamer1024 (13th October, 2018)
Is there any way to program atmega64 (still in circuit) troug PCs paralell port (with some resistors) like you can program atmega16 with AVR software?
Hi, I would like to use xprog-m as a k-line interface, how to set baud to 9600 8n1 ,how to Send Data and how to read Received Data.TimeOuts, multiplier's should be set to uart I suppose etc.
I know that it is simple to build K-line interface but why not use somthing that I already have.
I analyzed the protocol a little bit, but not everything is clear enough.
Regards Ficho
A good dump for atmega64 vers 5.0 ?
can anybody help ?
many thanks
Does anybody have the config file for programming atmega of xprog with another xprog? I only got flash and eeprom
Config: FC FF CA 2F
How i can download ? i don't have permission..
A Need good dump for atmega64 and LC4064V, vers 5.0 ?
can anybody help ?
Thanks in advance!
Hi Guys,
Can I use UPA USB to reprogram Atmega64 in Xprog-M thx ?
Way better than classic xprog, thanks!
Bookmarks