hi HH, just a short question...
when i change 1st time to the uneek environment everything works fine. then, after played "tintin" for a wile, changing back to the real nand makes also all things (cfg loader, hbc, etc.) working as they should. but if i then leave over the powerbutton on the wiimote (wii goes into suspend-mode - orange light) and power it up again on the next day then trying to go to the uneek environment again, it starts with a black screen and i have to make the wii powerless, to get it starting again. reproduceable all the time. by the 2nd "change" back into the uneek environment i did also not see any hd access (blinking flashlight on the hd).
i remember, there are some homebrew-apps, that power down the wii to another state (red light). this is the state i see, after making it powerless and repower it again.
Maybe this "state" is needed for me after using the real nand and go into suspend-mode.
do you know some of these "homebrew-apps" that can bring a wii into the "red-light" state?
greetings...
EDIT: just in time i found the reason myself...its the "wiiconnect24 standby option" in the wii option menu...if this is turned on, the wii goes into the "orange-light-suspend-mode" (that nearby also means 10watts).
if you disable this function it goes into the "red-light-suspend-mode" (this means 1watt).
So here you can also save much money.
this evening i will try out, if this works for me with my "black-screen-problem" and give some status.
EDIT2: after setting the "wiiconnect24 standby option" to "off" there is no more problem at all!
Last edited by keytouch; 16th January, 2012 at 08:39 PM.
I have modded wiis for years now but new to this. when I try to load the neek2o wad from the mmm all i get is a "ticket (-2011)" and wont install the channel. Can you help me on this.
i boot the channel and it goes black screen. I know it said it would take a while but how long is a while?
A long time is few seconds you are getting a black screen for 1 of 2 reasons either you don't have a game on the fat 32 partition or your emulated nand is not being recognized for which there is a number of reasons, but with knowing your setup I can't say what it is. Remember the install instructions are very specific as far as file structure and hdd format goes as neek2o is very picky
Have 2 wiis running SNEEK+DI now, but how can i get them to boot strait to it without using the NEEK chanel?.
Yes but then it loads postloader, and i dont want it to.
Bookmarks