If you have chosen to install uneek + di then you don't need an sd card to launch neek2o everything you need is in the copy to usb folder. Try launching neek2o from the forwarder without the sd card in it should work mines does.
My issues have been resolved. I used an old 256mb SD card instead of my 2gb Sandisk ultra card, I reformatted it to FAT 16 32k clusters. I then re-formatted my Hard drive to FAT32 32k clusters. Finally, when prompted in Modmii I went for install 72 instead of 75.
Unfortunately, because I changed various things all at once I cannot pin point the issues - if anyone gets a similar problem whilst running games (any with video cut scenes like tintin or the last story) then I would first go for the 72 install and see if that works. If not try a smaller SD card. If all else fails reformat the drive with the aforementioned fat 32 formatting tool in the tutorial.
Oh and don't forget to include the cios v14 when asked. I can confirm that v14 works alongside the above config.
Thanks to Highlander for the help, it's very much appreciated!
Last edited by mattblackhq; 7th March, 2012 at 10:29 AM. Reason: adding a bit extra
If you have chosen to install uneek + di then you don't need an sd card to launch neek2o everything you need is in the copy to usb folder. Try launching neek2o from the forwarder without the sd card in it should work mines does.
just posting
ive followed the guide and made it to the screen to set up my wii my wii but when it finishes it says i have currupted system files any help?
Sorry mate I'm not quite sure where your stuck. What have you done and what files do you have.
When I load the neek2o channel it says "Loading, please wait." and then it hangs at a black screen. What am I doing wrong?
Need some help here. I used the latest modmii to create a sneek+DI installation for neek2o. I installed the neek2o wad and it runs but I get stuck at the menu when the Wii prompts me to press the "A" button to sync the controller. From there I cannot proceed as the controller doesn't respond (as if it gets disconnected)
I initially tested a 500gb FAT32 HDD with 16kb cluster format. Got stuck at a black screen. 2nd time, I used a 1gb thumbdrive (fat32/16kb).. shows me the press "A" button screen and wiimote gets disconnected. Now I'm going to try a 4gb (fat32/32kb).. wish me luck
Crap, got stuck at a black screen again..
I used neek2o build 80 if that's stable. And mine's a hardmodded Wii with 4.1J so my emulated nand is 4.3J. AFAIK, since it's the same region I do not know why I get a black screen or what's causing my wiimote to lose sync..
This is what's inside my SDcard root folder :
I also assume that I need to create a wbfs folder in my USB/HDD drive and copy a *.wbfs game inside for neek2o to work?
Last edited by kokoronikui; 21st June, 2012 at 12:05 PM.
black screen when loading neek2o so posting to rechecking and seeing if modmii was the issue when making path structure
Bookmarks