Hi there,
I have in the past been able to softmod my kid wii by installing the USB GX loader. For him it is very easy to use but some recent games are not playable (ie, Tin Tin and part of Disney Universe).
While reading through some sites the instrallation of neek2o was recommended. I have followed the steps in the tutorial up and until running the SD and USB together for the first time. Once I boot up, and go to HBC all I get are 3 options (Joyflow, MMM and postloader). From what I gather, I should run preloader. However, all I get is a countdown looking for the USB and then an error message that the Configuration file is missing. While the countdown is going the controller is unresponsive and then once the error message shows up stating that I should boot from USB or SD, it simply hangs there.
I have the SD formatted in FAT and the USB (Western Digital My Passport USB3.0) in FAT 32 using EASUS. I have the USB set as primary partition and have 6 games (for testing purposes) in the WBFS folder, which were copied with Wii Backup Manager.
I don-t know what else to do. I have read about deleting the config file in the USB within the BIN file (not exactly sure what tool to use for this)... But I take it that this should not be the problem just yet, as I am unable to finish even the installation of the channels.
Anyway, any help is greatly appreciated. I am no expert on Wii at all (), so any patience is welcome as well.... ()
Thanks to all!
Bookmarks