CARPROG FULL

[albertros]

Cool, Reno Clitto 2001 - Spoke ro BCM - gave pin code out, but another tool said wrong code.

For a laugh tried to reprogramme the key, said entering pin, ok.

Saved the dump, Reno Pin Reader said bad dump.

Was able to edit the chassis number to something rude.

Will try and get an orginal and CP dump next week.

Carprog is realy annoying on this one. The dump in car prog is halved. A 93c66 dump is duplicated when read with an eeprom reader. Only half is displayed in carprog so when you import dump its too long. Then when you proceed it falls over ( carprog that is. )
Also when you power up the uch the dump is moded in the micro controller so then when read again its not quite the same.
There are 3 variations on the algo codes and carprog only does 2 of them well.
I always work in 8 bit mode on this one.

[Meat-Head]

Carprog is realy annoying on this one. The dump in car prog is halved. A 93c66 dump is duplicated when read with an eeprom reader. .

So sake of argument the costomer wanted the code say.

The dump carprog made, cut and paste it's self into say usb-upa, xprog etc, save then run through zedbull or reno pin reader, then, bingo number is.........

So 'what' was the code on the screen and 'what' is the correct code (will TRY and upload dump next week)

[albertros]

So sake of argument the costomer wanted the code say.

The dump carprog made, cut and paste it's self into say usb-upa, xprog etc, save then run through zedbull or reno pin reader, then, bingo number is.........

So 'what' was the code on the screen and 'what' is the correct code (will TRY and upload dump next week)

I don't know is the answer, but guess its the code for one of the other algo's