CARPROG FULL

[dimet]

when you use k can 1.4 to comucate with ecu select k line an it will give you opton to read ecu.I tray that on my car golf 5 2006 ecu me 7.5
I menaged to add key and change km dash VDO 24c32 with car prog it gives me cs an pin(cs written on transponder with tango)
laguna 2003 add key card ok(I read uch 912 with upa for backup)

(nema komunikacije preko K linije probano, komunicira samo preko CAN-a i opcije za ulaz u motorni kompjuter u programu su neaktivne)

No communication via K-line, communicates only via CAN and options to enter in the ecu are inactive

[Music73]

Darn.... Counter appeared today... 255 uses till update...

Looks like its time to start to rig up the jtag interface..

Was using 4.85 on clone to do airbag from pug 207... Read and write ok but didn't change anything... But went back to 4.01 and dropped another use but read changed and wrote.. haven't tried it out yet though...

Music73

[strato]

(nema komunikacije preko K linije probano, komunicira samo preko CAN-a i opcije za ulaz u motorni kompjuter u programu su neaktivne)

No communication via K-line, communicates only via CAN and options to enter in the ecu are inactive

This is OK,clone CarProg,ali kako cita zakljucane MCU?
Pozdrav.Thanks

[dimet]

This is OK,clone CarProg,ali kako cita zakljucane MCU?
Pozdrav.Thanks

I have not tried it but I think does not read locked mcu

[Shmortz]

Tried friends clone carprog today on bosch m1.5.5 from corsa c with my bench rig. No extra power supply needed on my friends clone.

Read security code perfectly.

did someone read with success pin from M1.5.5 Corsa B X10XE MCU, I'm recieveng only 0000, tryed 2 ECU's on car and on the desk same result...

[markony79]

did someone read with success pin from M1.5.5 Corsa B X10XE MCU, I'm recieveng only 0000, tryed 2 ECU's on car and on the desk same result...

Original work Perfect

I never seen in my life so much post and chating about one clone product!!!!!

the Carprog Clone can do "LESS" (little) then what can do
UPA and Tachosoft and Nyo4

[Shmortz]

hm, my clone cannot do it...

[oep]

Mine also reads 0000
But i can change vin ...

[v-diag]

whats the value of the resisters on the picture?

[arturkob]

whats the value of the resisters on the picture?

I must be here

[hussei]

I check the software, most airbag reset by direct connection which is not good

Most of menus marked with "N/A"
what is N/A means? not available or not applicable?

i have new version and i sit here saturday for all body need it and carprog very good work and any think u need just send me massage ok

[bearheroes]

i have new version and i sit here saturday for all body need it and carprog very good work and any think u need just send me massage ok

why message?share your knowledge.

[tomek3232]

whats the value of the resisters on the picture?

The resistors: 10k

[oep]

ouch, somebody break N/A already?

[dimet]

Can i change mileage on Touran 2007 with micronas?