I have UART1 - error during testing with A9 test adapter. Do you have any solution for this? It's original one and I have already replaced all 74HC125M.
Results 1 to 15 of 2954
Thread: CARPROG FULL
Hybrid View
-
21st September, 2016, 12:19 PM #1DK Veteran
- Join Date
- Jul 2015
- Posts
- 378
- Thanks
- 69
- Thanks
- 115
- Thanked in
- 105 Posts
-
21st September, 2016, 02:03 PM #2V.I.P. Member
- Join Date
- Nov 2013
- Location
- Outta This World
- Posts
- 1,996
- Thanks
- 691
- Thanks
- 2,206
- Thanked in
- 841 Posts
Usually get that error if you don't replace the resistor too or solder wrong spot..Did you make the A9 adapter yr self?
Originally Posted by gokart
-
21st September, 2016, 03:08 PM #3DK Veteran
- Join Date
- Jul 2015
- Posts
- 378
- Thanks
- 69
- Thanks
- 115
- Thanked in
- 105 Posts
Thank you for your reply. The resistors and soldering are OK. I made the adapter which is 100% correct. Finally, I solved the problem. It was a small manufacturing problem on the PCB. Now, works fine. Originally Posted by FxShaw
-
21st September, 2016, 03:36 PM #4V.I.P. Member
- Join Date
- Nov 2013
- Location
- Outta This World
- Posts
- 1,996
- Thanks
- 691
- Thanks
- 2,206
- Thanked in
- 841 Posts
Can we see a pic of that and where it was just in case someone else have the same issue in the future? Originally Posted by gokart
-
The Following User Says Thank You to FxShaw For This Useful Post:
Levanime (21st September, 2016)
Reply With Quote
Bookmarks