DAS XENTRY connection problem

[Harrycz44]

Did you test x-prog from your SDS virtual machine or from a different virtual machine?

Do you mean how to configure SDNC to use C3 (SDConnect is the new, wireless mux, I thought you did not use that). It should be sufficient to set cal.ini to "D2" and once you plug your C3, your computer detects it.

yes I tested on das system.. I have old C3 mux o)))

[Harrycz44]

I tested today version 1/2011 = work, 7/2011 = dont work, 11/2011 dont work on my car. I think that missing any fix solution. I change cal.ini from 1/2011 to 7/2011 and same = dont work. Who help me pleas??

[yriy66]

http://www.digital-kaos.co.uk/forums...70/index2.html read post 28

[Harrycz44]

http://www.digital-kaos.co.uk/forums...70/index2.html read post 28

Hello this files are for 9/2011.

[DB_member]

Hello this files are for 9/2011.

I think he is referring to the blacklist solution. The same solution should work with 11/2011 as for the 09/2011 release.

But you do not need any blacklist fix to pass CAESAR self test. Assuming your self test works at the VMWare environment.

I cannot remember your error with real diagnosis, you probably mentioned it already.

[Harrycz44]

Yes, maybe this problem about black list come later. First time I must solve this problem. But I am skeptical now.. I made any printscreen

[DB_member]

Where did that last figure come from? Which release did you test there?

What happens when you do real diagnosis with a car and which car did you try?

If the last figure is from your 11/2011 setup, you do seem to reach the mux fine although you don't show the complete results.

Perhaps the blacklist fix is after all your only issue?

EDITED: now I realised you do not have the PartD mux listed at the first figure, it should be there but I don't know if the blacklist test has been performed before the mux is shown here.

[Harrycz44]

DB_member Thank you for help me and your support.

I did new install 11/2011 and after I use fixDmux from Mr. Patrian. Caesar test work later I will test it on my car. Now I go install wis o))

[friskydoo]

Hi there I have the same issue I have a t30 with 09/2011 software xentry all working fine but cannot connect to the vehicle it is a new install and has not worked have done a ceased test and comes back fine the com port is on 2 but still not talking to car the t30 acknowledges its there but no communication with car all this is new to me so it will have to be put in simple terms.thanks in advance

[DB_member]

Hi there I have the same issue I have a t30 with 09/2011 software xentry all working fine but cannot connect to the vehicle it is a new install and has not worked have done a ceased test and comes back fine the com port is on 2 but still not talking to car the t30 acknowledges its there but no communication with car all this is new to me so it will have to be put in simple terms.thanks in advance

So you are not using a VMWare setup? Do you mean the CAESAR self test is fine but diagnosis with the car does not work? If so, give us the exact error message, post a screen capture if you wish.

Which car are you testing (are you using DAS or Xentry)? Did you apply the blacklist fix?

Note that you can never give too much background info.