A search is all that's required
Kernel Update
A search is all that's required
Kernel Update
How I can unbrick Max+ solo clone?
Thank you!
I did it, bricked my vu+ duo clone by using the solo bootloader. Darn...
Is there already a way to fix this?
Last edited by benny/9; 26th September, 2012 at 08:32 PM.
Please Read Carefully!
No Sky UK NDS Videoguard Hacking Discussions.
Viewing Pay TV without a valid subscription is illegal
the files available are kept for experimental & educational purpose only
original vu duo2 /vu zero/ tm-nano-se. v-box / 36v /1.2 dish,
thank you lot
Good morning to all I ask for help for my vu + clone had only 166 image I discovered later that it was a clone, but now I had purchased I updated the kernel to 3.1.1 then 1.7.6 then also the image but no 1.7 .5 1.7.4 1.7.3 1.7.2 and still nothing does not work now even with the 1.6.6 what should I do? please help thanks
1 -installing the soloboot.bin with UpdateAllFlash.exe
2 -installing the UPFLASH120227.bin with renewflash.exe
3 -Erase the memory with ERASE126.exe
4 -installing the Secret SOLO-120229.bin with secupd111230.exe
5 -installing the cfe_solo_2.0 with a usb pen drive
6 -installing a image XX with the usb pen drive
but nothing help me please
If it's solo post in the solo section and welcome to Digital Kaos.
please let me download this
when i try tot do "VU DUO secret chip update 120229" with null modem kabel en board, receiver starts, and display shows "Starting"....
afther 5 min, still the same
i just instaled BH 1.7.3 whitour problems
do i still need update?
regards,
If your vu+ duo clone has a v2 sticker on the back it's already been done. Does it have this sticker?
thanks for reply
no it has no v2.0 sticker
i manage to update on other pc with integrated com port.
with usb2com adapter not worked on my (this) pc
thanks
regards
As digicon gives you ic update on post 1 you seem to have done this but he also gives you bootloader on post 31 which it seems you have not done. So if you have clone v1.......
1 ic update via board and null modem cable
2 format usb unzip bootloader [make sure you have correct one for your box] put on usb then flash this takes seconds.
3 format usb again load image to usb [Again correct one for your box if your not sure ask] then flash do not pull out usb until done once finished reboot.
If you read the whole thread you may get there. Any info is for help only fiddle about at your own risk.
Last edited by DOUGALMCD; 15th August, 2012 at 09:03 AM.
Last edited by satmandanuk; 31st August, 2012 at 12:46 PM. Reason: bad spelling :-(
This has 3.1.1 kernel.
Good idea to make a full back up before you flash.
menaco (22nd May, 2014)
Bookmarks