KEFCO mg 7.9.8 ECU swip

[foxdata]

hi all
i have Hyundai avante 2010 with damage ecu (the car without immo box) ecu KEFICO H89
39120-2B003
MG7.9.8

i replace the ecu with new one (the new ecu from car with immo box) ecu KEFICO H10
39120-2B000
MG7.9.8

-the two ecu have same structure and ics and have 95160
-i try to read 95160 form org ecu but the superpro u580 programer say the chip protection and gave me the date of it but i think its not all data of 95160.
- i try to swap the 95160 form the org ecu to new but the car cant start and the carman say the smarta immo problem .
- - - - - - - - - - - - - -

please.. any one have a good dump for 95160 for the new ecu (without immo) or immo off to it

[foxdata]

hi
i try to swap the one of ST10F275 (the one connect to 95160) from old ecu to new after that the car run fine and the gear is ok too but after 30 min the new ecu is dead too and the chk engine signal (chk engin lamp is disappear ..
i test all ecu connection and all supply is ok.
plz any one have any idea .???

[foxdata]

hi all
i need the good dump for the two st10f275 and 95160 for the ecu (the ecu for hyunday avante or elentra 2009-2010 with out immo)
KEFICO H89
39120-2B003
MG7.9.8
if possible

[toximatic]

Dead coz of soldered joints of the st10

[Chongcheeluan]

hi mate can share me immo off firmware