xprog and 68hc12d60

[bluedid]

I try to read a 68hc12d60 (Nissan Micra airbag 98820AX51A bosch 0285001474) with xprog with no success,it start reading and it does not continue (I have try with BDM and without , follow conections from xprogm manual) . I have xprom 5 clone full auth. I read it with UPA without problem. why ? can anybody help me?

thanks

[karalada]

The following way :

9 - Vdd
10 - Vss
15 - BKGD
26 - Mod B to GND
27 - Mod A to GND
34 - Reset

[bluedid]

The following way :

9 - Vdd
10 - Vss
15 - BKGD
26 - Mod B to GND
27 - Mod A to GND
34 - Reset

thanks I have allready try this but same result.I donot have make the Errata correction of the BDM should I made it because it is for secured ARM MCU ?

[tatyanka]

My Xprog-M clone from obdauto doesn't work with HC912 and 9s12 ether...bad clone

[bluedid]

I have buy it from ecutool maybe I have the same problem...

[bluedid]

but I have read a Peugeot BSI with 68hc912 from 307 2003 1,6 Valeo so it read hc912

[karalada]

Try lift - Mod A, Mod B and Reset

[bluedid]

I will try and report.. thanks

[synkrotronic]

Hi
External voltage could give you problems on reading,if is low

Regards

[bluedid]

Hi
External voltage could give you problems on reading,if is low

Regards

I use a 12V - 2A ac adapter is not good? (because I read 15V - 0,35A in the manual)

[obd.tech]

usb or comm connection to pc?
just a thought?

[bluedid]

Try lift - Mod A, Mod B and Reset

I try it but not work (I dont conect ModA and MobB to ground)

[bluedid]

usb or comm connection to pc?
just a thought?

I try to read and write a 68hc12be32 all ok
I have made it with power cable and without it.