i had try to update my vo+clone to version 2 whit my omoddelcabel i try from winxp to update the update start fine
put i stant still for about 2% of the update an nothing
more happing it dont finish the update now the v0+clone
dont start anymore it just show starting in the display and nothing happings is the a way to flash i back with the omoddelcabel
thanks jj
Last edited by benny/9; 26th September, 2012 at 08:32 PM.
Please Read Carefully!
No Sky UK NDS Videoguard Hacking Discussions.
Viewing Pay TV without a valid subscription is illegal
the files available are kept for experimental & educational purpose only
original vu duo2 /vu zero/ tm-nano-se. v-box / 36v /1.2 dish,
big thanks benny/9
but after many try its udate 100% but now when i put power on i can hear the vo+ run but there i only a little red light
in the display and nothing happing i thinks my clone vo+
is broke
***************************************
if your sure you have updated the box with the rs232 board
and the null modem cable, then put a image on a usb stick
and see if you can now flash the box first tu rn the box off
with the switch on the back panel, then put the stick in the
front usb port and turn the box back on and it should say reading usb
on the box lcd screen leave it to flash the box just follow the info/instructions etc;
on the lcd screen on the box untill it says remove usb and re boot
then remove the usb and turn the box off and give it a few seconds
and turn on again then the box should be flashed and ready to set up
Please Read Carefully!
No Sky UK NDS Videoguard Hacking Discussions.
Viewing Pay TV without a valid subscription is illegal
the files available are kept for experimental & educational purpose only
original vu duo2 /vu zero/ tm-nano-se. v-box / 36v /1.2 dish,
i thanks for you big help benny/9
but nothing happing when i turn power on there is only a
red light in display and nothing happing
no is was a version 1 but i think the botfil is gone or maybe i all broken is there not a way to flash it back to factory version
thanks
jj
Last edited by jj2; 10th May, 2012 at 06:57 PM.
********************************************
first mate did you use the duo_scret file when
you updated the box? with the null modem cable
if not i have added it to do the update again
if you want to try the official vu firmware
you can find it here:-- Archive of Vu+
make sure you use the file for your model
Last edited by benny/9; 26th September, 2012 at 08:32 PM.
Please Read Carefully!
No Sky UK NDS Videoguard Hacking Discussions.
Viewing Pay TV without a valid subscription is illegal
the files available are kept for experimental & educational purpose only
original vu duo2 /vu zero/ tm-nano-se. v-box / 36v /1.2 dish,
Bookmarks