Powergate problems

**physyc** · 4th May, 2012, 11:19 AM

Hello,

I'm new here.

i just received a hacked powergate (original S converted to full 3.83, not chinese clone)

When i try to read ford focus 2 tdci 110hp i keep getting error 00 02 and error 00 01 no communication with ecu.

No mather what driver i take. id, dtc, nothing works.

what could be the problem?

I also received mpps (combine shipping for a friend)
i want to try to read the ford, but how to know what driver to use? there is edc16C3, 16C34-2 and 16C34-5

**ipejasinovic** · 4th May, 2012, 01:36 PM

Did you check what ECU you have in your car?

**pinch** · 4th May, 2012, 06:14 PM

PWG should work and it should be EDC16c34.
Have you tried the PWG on any other vehicle ?

**Marmes** · 4th May, 2012, 06:38 PM

Bad conversion of powergate

**pinch** · 4th May, 2012, 06:40 PM

Doesnt bad conversions usually gives the Internal Hardware error 99 ?

**Marmes** · 4th May, 2012, 06:42 PM

not only that.
check if the cable you have is the original one also.

**pinch** · 4th May, 2012, 06:56 PM

How do you spot if its the real cable ?

**Marmes** · 4th May, 2012, 07:52 PM

is it green or totally black?

**pinch** · 4th May, 2012, 08:03 PM

totally black

**Marmes** · 4th May, 2012, 09:12 PM

when you open it is there a small board and somewires soldered or is it totally clean?
Try to exchange the cable for one original with green end. ask someone who might have it just to test. If the problem maintains, then you must return to who sold you the interface.

**pinch** · 4th May, 2012, 09:33 PM

Its a board and wires soldered to it, its a slave thats been hacked and works with both 3,73 and 3,86 but not on ford, like its supposed to ...

**Marmes** · 5th May, 2012, 12:55 AM

is the board the old version or the newer version?
newer version has a small 8pin chip from AD for rs485 near AT90can and older version has an OKI chip near AT90can.

**pinch** · 5th May, 2012, 03:48 AM

Its the one with OKI chip.
Might you know what the problem is, and if it can be fixed ?

**physyc** · 7th May, 2012, 09:45 AM

i have also orginal cable.
Black cable with green tip on the obd side.

I have to try with other cars.

**physyc** · 7th May, 2012, 09:49 AM

Anyone can post pwgpro 3.86 here so i can try? It was told to be able to use upgrades.

i'm not sure to download the latest version from the webssite.
If i go to high. will it kill the flasher or will it just not work? And work again on lower version?

Thread: Powergate problems

Thread Tools

Display

Powergate problems

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions