EZS 211_ST12 reading by xprog_m

**bangreno** · 20th May, 2012, 04:19 PM

Please can somebody confirm if I can Read EZS from W203.
On board is written W211_ST12

**MarkPRP** · 20th May, 2012, 04:35 PM

yes

connect as rosfar diagram, and then select 9s12 secured eeprom

mark

**Shmortz** · 20th May, 2012, 05:58 PM

here is everything you need, read carrefuly...
if you get 'verify error' after reading click NO and read again, otherwise MCU flash can be deleted...

**16eddi67** · 20th May, 2012, 06:01 PM

Originally Posted by bangreno

Please can somebody confirm if I can Read EZS from W203.
On board is written W211_ST12

Hi ,
Xprog-M MB211

**bangreno** · 20th May, 2012, 08:34 PM

100% clear as diagram.
Managed to read 9St2, please can you check if dump is ok and calculate some keys .
I could not got original Coax or Twisted pair, so I built one with WIFI antena cable.
I didn't use XCLKS.
My doubt is about Reset pin not same in above diagram , and some resistors was to be remove in the second diagram.

**smayer** · 20th May, 2012, 10:20 PM

Originally Posted by bangreno

100% clear as diagram.
Managed to read 9St2, please can you check if dump is ok and calculate some keys .
I could not got original Coax or Twisted pair, so I built one with WIFI antena cable.
I didn't use XCLKS.
My doubt is about Reset pin not same in above diagram , and some resistors was to be remove in the second diagram.

your dump is OK
WDB2030071F48xxxx
356556,8Km
Keys used 0,1,2,3 and 4