307 2007 bsi dead

[exorcistaecu]

the bsi is:
jonson controlrs

96 601 059 80
BSI 2004 H05-01220705

boot 21676031-5b
V02-00
Hard 28113346-8a
281148373a
F01022217

After correcting the number of kilometers on the dash (95,020) and bsi (95 128) read and write with UPA USB.
The car seemed ok then tilt lights, wipers and now no sign of life, that a possible solution?

[andrze]

Put all FF in BSI eeprom and then telecode everythink by PeugeotPlanet
Regards

[Shmortz]

try to put back original files and should work, then try to change km corectly, the last solution is to find pin code from engine ECU or bsi memory dump and recode BSI with PPS

[exorcistaecu]

I am attaching the original files and the files modified to 55km can check if they were made were not good is the cause

[barti122]

try this file

[exorcistaecu]

orig files first try to see if it resumes normal operation!
pps do not possess, ACTIA multidiag I would come in handy?

[Shmortz]

old km is 112075, dash correction is good, bsi was reset to 0 km
here are files dash and bsi 55000km

[exorcistaecu]

I put the original files, the display has funzionanto dash for a couple of times every visuallizzando 00000 but then no more! I do not work windows, low beams, climate, stereo and the central display mode active economy what should I do?
Dash + BSI attach files read after having returned to the original

[barti122]

read upa? in the inside or outside . IF outside maybe wrong solder. as programmed eeprom, you've just read again to make sure it has written a well
sometimes the bad can write upa

[exorcistaecu]

EPROM read and write outside ,the speech that the car after the first operation worked but then it went haywire

[barti122]

I had the same once the 407th when I change the course showed up alone 00000. Later I found out from the dash and BSI have the same value set. and the car worked normally. which shows a PP2000. some errors

[exorcistaecu]

I do not understand what you mean

[barti122]

planet pp2000 error ??

[exorcistaecu]

I do not own the PP2000, but I only ACTIA multidiag from ECU missing forever if I did not need adapters obd!

[exorcistaecu]

changed again with a new car battery dump file orig dash display but does not display the correct values, and the dash to light after about 5 min in motor ECU error u0028 instrument panel!
else DPF abnormality of the central display, glass is not working right ..