Hi I'm trying to read the file from my Polaris Rzr of 2008 for editing. As you do that? With that software and interface? Sorry for my English translator.
Thanks in advance
Hi I'm trying to read the file from my Polaris Rzr of 2008 for editing. As you do that? With that software and interface? Sorry for my English translator.
Thanks in advance
I use Beprog and read 29f010b
Regards
you need to read whit bdm rzr 800 read TC1766
Alpinesport Hi, this is my circuit board and I see no TC1766, you know that I have to connect pin BDM?
Polaris official interface communicates with three wires, 1 positive (+12 v), 2 negative (ground), 3 direct to ecu pin. There is a connector for a 9V battery that says the manual is for ECU reflash the positive goes directly to ecu pin and negative to ground battery.
Would be helpful Thanks
Last edited by piltrisi; 14th June, 2012 at 04:38 PM.
I can tune it, throw me a PM.
I need so mutch chiptune my ecu.. any help... I pay if needed
Regards
I found maps by myself and now it runs like a charme!!
Regards
I'm happy for you
Last edited by piltrisi; 1st July, 2012 at 02:28 AM.
I have been a few days away, I will resume work on the ECU. Let's see if I can find the maps as you and calculate the checksum. If I can not and I'll ask a little help
thanks
Bookmarks