hello all dk i need fix SBC W211
fault code C249F check operating time of coponent A7/3
some know how fix maye eeprom?
thanks
hello all dk i need fix SBC W211
fault code C249F check operating time of coponent A7/3
some know how fix maye eeprom?
thanks
Use Das developer.SBC UNIT EXTEND SERVICE LIVE
UNDER NO CIRCUMSTANCES USE THIS PROCEDURE MORE THAN ONCE ON ANY CAR AS TRUE SERVICE LIFE OF SBC UNIT IS AROUND 160-180% OF WHAT MB SET THE UNIT AT
Make sure engine is running !!!
In Developer mode you need to go to Entwickelingsdaten - > ansteueringen -> Gesamstliste aller Ansteuerungen
to see how many times brake has been pressed there is a line that says: Bremsenzahler (DJ_GetBrLive)
then 1 line down there you see Bremsenzahler aktualisieren und Lebensdauerzahler F neu berechenen -> click it !
Parameter uINBR = 0
then click F3
1 line down Bremsenzahler auf beliebigen Wert setzen (DJ_SetNBr) -> click it
Parameter uINBR = 0
then click F3
then scroll down untill you see the line's :
Lebensdauerzahler F neu berechenen (DJ_CalcLiveTime)
Parameter uINBR = 0
then click F3
Lebensdauerzahler F neu berechenen und schreiben (DJ_BuildAndWriteF)
Parameter uINBR = 0
then click F3
Log out of SBC !!
log out of verhicle !!
let engine run at least 10 minutes or drive at least 10 minutes
If no coils are damaged , SBC fault code is not AKTUEL no more
Last edited by smayer; 24th June, 2012 at 04:29 PM.
there was a thread about this somewhere, might have got binned when the software section got the door bricked up, but basically said 300,000 times of brake pedal presses, locks out and ALWAYS put new brushes in the motor.
The only intrest i have in these, is as dick wad comes in his, - he drives like a cock, is press his brake pedal untill my legs hurt - puts a bit more wear on it for him
HTH
Meat.
Was Banned For Being Certifiably Insane and Stupid
Bookmarks