Digiprog 3 clone questions and answers

[AEservis]

CAN comunication no work, if someone know what is problem? All relay in obd cable tested works, can ic changed no result.

[andrejjo]

Hi everyone,

is it possible to repair corrupted data after using digiprog 3?
if it would be necessary to purchase a new dashboard?

10485824 Internal control module memory check Sum error
Odometer show only: ------ , in VCDS i see Mileage 16777215 (broken dump after digiprog 3)
Cluster Nr: 7P6920882M

[tanon]

Hey all, sorry if this is a dumb questions. I have a kawasaki z800 2013 and I am trying to correct the mileage on the odometer (93C66) will digiprog 3 work for that? And should i worry about disordering the chip from the board? First time doing this any advice will be appreciated!

It can be done. I have already done it. Specify the model in the machine as zzr1400. You can adjust it.

[brend]

Hi everyone,

is it possible to repair corrupted data after using digiprog 3?
if it would be necessary to purchase a new dashboard?

10485824 Internal control module memory check Sum error
Odometer show only: ------ , in VCDS i see Mileage 16777215 (broken dump after digiprog 3)
Cluster Nr: 7P6920882M

DP4 , POLDIAG and other elit tool can do this repair obd2 away .

Find this tool and repair .

[Happy786786]

DP4 , POLDIAG and other elit tool can do this repair obd2 away .

Find this tool and repair .

Hi
You can try read and write with Dp4
It should repair it


Sent from my iPhone using Tapatalk

[hass42]

Hello all....
I don't know if I'm allowed to say this in here so I'm sorry to admin if I'm not.

But I'm looking to purchase a DP4 if anybody has any leads on a used one out there?


Hass42

[xmalakx]

Hi
I have a question
I have DigiProg3
I repair Ducato/Boxer/Jumper cluster 399.999km.
Now I take cluster, open, take out eeprom, read, program, verify, put back to the motherboard and everythink is OK.
I saw some extra cable to buy to digiprog.
If I buy this cables can I program eeprom without take out chip? I saw many cables to many cars, if I have those cables can I connect whole cluster direct to the digiprog 3 and program?
Best regards

[skens]

hi
remove the eeprom, read it, set it to 00, you solved the problem! The safest way to read the eeprom is when it is removed from the pcb
regards

[xmalakx]

Yes You have right and now I make in that way. But I was wondering that cables can connect cluster to digiprog directly and can program eeprom without remove from pcb? Best regards

[rtbdiagnostic]

MB Sprinter Tachograph Kienzle,on soldering points,went fine.OK
br,

Howzit looking for soldering points for Kienzle 1324 Tachograph with Digiprog 3
Anybody can share please ?

[xmalakx]

Hi, I made a table set to program eeprom without.
I made a OBD plug with power voltage GND, +12V always, +12 ACC, and Can H, Can L from cluster to DigiProg3 and DigiProg3 connect correct to Ducato/Boxer/Jumper clusters 2006-2013 and correct program eeprom from 399.999km to 0km

[Kimoo2000k]

Hello my friend
Can anyone help me in my problem
I connected wrong cable to digiprog so now
I can't read the eeprom via chip
Please help me if you can