Must work,
Must work,
Anyone already use digiprog one a Renault Laguna 2 with HCS12 eprom? It's to use the cable 48 but when I use digiprog to read, its rebooting! I think Ford F150 uses the same eprom.
Take off the dash and open it and read that mcu and post dump hererfclusters
I think i am gonna put ur file in a cigarette and smock it with weed of course.tell me what is ur actual mileage and hiw much u want to change?rfclusters
rfclusters (22nd April, 2019)
For those who use clone Digiprog, be aware that ST48 have the power and ground cables swapped (i detected this issue on a Renault Laguna 2 with HCS12 MCU).
Regards
galaxy0634 (22nd April, 2019)
Wait some more time after you will see Lo 3-3, the tool is working. Do not disconnect your DP3 or touch anything.
The procedure take some time and it's a common mistake that people panic after Lo3-3 appear.
2012 chevrolet trailblazer will digiprog work on this dash - i.e read write chip in bcm chev cruze option is it same for trailblazer - or is there option for bcm via obd with digiprog - advice appreciated
'If I helped, please click Thanks +Reputation.. !'
2010 VW Transporter dash via obd 2 is it possible with with digiprog and also would it be NEC 24C32 or NEC 24C64 option ? See image attached
'If I helped, please click Thanks +Reputation.. !'
Dash out I believe
Sent from my iPhone using Tapatalk
seems this could be the solution NEC 24c32 (facelift) with digiprog see pdf
Last edited by rtbdiagnostic; 5th May, 2019 at 10:33 AM.
'If I helped, please click Thanks +Reputation.. !'
rtbdiagnostic (6th May, 2019)
Bookmarks