quick one for those in the know, i have searched extensivly but cannot find for sure .
will digipro 3 v4.94 work via obd on 2013 1.6 econetic mondeo - model with touch screen sat nav ( is this called color screen model ? )
thanks for your help.
Well guys after 3 years my digiprog 3 died. So I ordered another one on Ebay it would not read miles or hours. So I'm in the process of getting a refund. My question is where can I get a good digiprog clone that will work without the bs. My old digiprog that was good just stays on a blue screen and that's it. I did replace the ic chip that I borrowed from the 2nd one I got but still no change. Also has anyone used the obdstar odomaster?
quick one for those in the know, i have searched extensivly but cannot find for sure .
will digipro 3 v4.94 work via obd on 2013 1.6 econetic mondeo - model with touch screen sat nav ( is this called color screen model ? )
thanks for your help.
alladdin (15th January, 2020)
Hello,
digi3 4,94m
Passat b7 2011 2,0tdi dsg. Getting unknow version. Maybe choose another model ? If i chosee passat b6 2012- its see version but wait its show try and counting...82578016_2253132141653611_283465646807711744_n.jpg
Also need edit just instrument cluster or ecu and dsg too dont see millage ?
photo link:
https://prnt.sc/qqagqv
Last edited by Edvinas111; 20th January, 2020 at 04:04 PM.
photo.jpg
Will digiprog do a 2011 ford f150 dash like this one?
device not fond, the comnumber property of the tapdcomport has not been set.
hello, someone has crack for eČ-tool? I can't connect with my digiprog it gives me an error message
Hello mates!
Dose anyone have some collection what can do dp3 and what better dont try... And maybe new pdf guides or something useful because im new in this businesses. but not new in regular diagnostic
hello, problem solved, I didn't have the right software, can you give me the technique to delete the eproom file and send another one?more precise add a binary file in eprom file to enter it in digiprog by eČ-tool
Last edited by Rglisse; 11th February, 2020 at 06:45 PM.
I have a digiprog ver 4.94 it works but cannot connect to Pc.It was missing the eeprom. ftdi and resistor.I soldered the 3 of them on and still get the error on EEtool device not found Comnumber error. In device manager it shows it on the comport.Does this not work on Windows 10 ?Anyone have a clue?Thx
Hello,
BMW e91 2006 330d. Works by obd ? and how to done ?
First cas
secound dash ? or no difference ?
First time touching bmw for for stupid question
Bookmarks