Carprog Mcu Reflash Step by step

**Domi** · 13th December, 2018, 12:13 AM

mrchip // Bad soldering on header PCB or bad wires ( maybe wrong connected to programer J-link // NRST to RESET )

**kebappa** · 20th December, 2018, 05:23 PM

I do it without problems

**elremont** · 8th January, 2019, 09:08 PM

Originally Posted by picus16

Attachment 391430

Attachment 391431

dump AT91SAM fully active ecu vag and online version +lib

https://mega.nz/#!1otyQDiL!2qZ943mzX...Y2CWyEEQckNvUY

please dump friend,link not work

**elremont** · 9th January, 2019, 06:37 PM

friends maybe can me give dump AT91SAM with fully active ecu vag and online version +lib?

**elremont** · 9th January, 2019, 10:01 PM

I can read edc15 edc16 eeprom with carprog and A1 adapter via obd?I try but not work

**joker01** · 25th January, 2019, 10:58 PM

guys have carprog sn 150428 car00542ua,which is the latest firmware available .... I have already killed a mcu I did not want to use a wrong file...
thank you so much...

**joker01** · 3rd February, 2019, 02:54 PM

guys I changed 2 new mcu but j link does not recognize me any of the 2 ..........
I tried to pin 55 to 3.3v for several minutes but nothing ..... where am I wrong ????

**Majstorcev** · 6th February, 2019, 09:53 PM

pin 55 is in short connection with GND pin 60 check this

**Stelaras26** · 8th February, 2019, 09:26 AM

i have programmed 3 carprogs like this with a 10euros jlink..

I dont unsolder anything from the back of pcb,i dont lift any pin of the mcu....

much easier way,it took me 3 minutes each.

**joker01** · 9th February, 2019, 10:30 PM

I see 6 cables connected, in my instructions I have 7 cables to connect..........
the first on the left on vtref of jlink

**joker01** · 9th February, 2019, 10:48 PM

the pin 55 mcu raised must be shorted with 60 mcu pin ???
I do not have any shorts between the 2 pins

**Stelaras26** · 19th February, 2019, 08:57 AM

Originally Posted by joker01

I see 6 cables connected, in my instructions I have 7 cables to connect..........
the first on the left on vtref of jlink

There are many instructions in here and on the net...
You can try any that you want,but this one i uploaded,i use it all the time..

**joker01** · 24th February, 2019, 06:56 PM

solved guys !!!!!! I unsoldered and resolded mcu, maybe a few feet was not ok.
I loaded firmware 8.21 with file lib 150428, some protocols are still blocked example airbag alfa romeo bosch 50527474.
it's normal????