Hello,
Have you engine serial number ?
I found this :
I am getting fault code 2559 on Cummins ISBe engine mounted in DAF LF45 but there is no troubleshooting steps for this code.
Can someone advise how I can get the troubleshooting guide for this code.
The engine starts and runs for 30 seconds and then die and the fault 2559 is shown as inactive but the count rises every time you start and engine dies.
Thanks for any help
Hello,
Have you engine serial number ?
I found this :
Last edited by kitty-hawk; 1st October, 2012 at 04:34 PM.
dannyklx (10th June, 2014), Evan williams (3rd April, 2018)
For download calibration i need ecm code. (number of calibration)
You did not make a recording with Insite ?
No my friend, I never had this problem.
Engine SN: 21527393
CM 800
I will see
I managed to get get customer to bring the truck to the shop today.
I really need the Cal File to try and see what happens
Here is the information
Engine SN: 21527393
ECM SN: 83907108
ECM Code: T90099.04
Cal Software Phase: 01050605
Hope this information is adequate
Thanks
NEED HELP
I tried installing Cal File in ECM but Insite is giving me this message
"INSITE could not detect calibration for the selected ECM"
These are the steps I went through please advise if I am doing something wrong
1.I installed the file in calibration workspace
2.I connect to ECM and opened calibration selection
3.A red dot was shown next to calibration workspace
4.I clicked on it and a drop down box opened, then I clicked on automotive
5. The cal file appeared yellow in colour
6.When I clicked on the cal file then I get the above message in the right hand column
What am I doing wrong please advise
Thanks
Bookmarks