Help with A/C Audi A5 2008, air fan not working, help!!

[electrones]

Hi friends

I went to see the Audi A5 3.0 tdi, 2008 that has problems with A / C.
I tried to turn the A / C in the automatic, light turns red then is gone, not stay and the cabin fan does not work.
I made Diagnostic, dtc:
01087
03023
01844
I think climate control module needs to be reset but do not know how, too thought the fan resistor may be dead.
How i can redefine/fix this dtc.
Cheers

[genius76]

01087

Indication in the tester-VAS 5051A-and output to the printer			Possible cause of fault		Remedy
1087
Basic installation is not carried out
			t	During the execution of the "Basic Installation" there is a fault or the ignition was turned off and the unit Climatronic-J255-could not complete this function.	-	Perform basic installation unit Climatronic-J255-
t	After replacing the Climatronic-J255-has not been performed basic setting.	-	Check the code passed through the system bus data on the block Komfort Climatronic-J255-(Read measured value block, display group "019") → Chapter and then perform a basic installation of the unit Climatronic-J255-→ Chapter.
t	Basic installation was performed on an unprogrammed or improperly programmed block Climatronic-J255-.

VW Touareg (7L) Heating/Air Conditioning - Ross-Tech Wiki
VW Golf (5K) Climatronic - Ross-Tech Wiki

GOOGLE IT VCDS Climatronic control unit J255 basic setting

[genius76]

forget, post here engine and gearbox codes will post here wiring diagrams if u like


also some info here sorry for inferior

http://www.audi-portal.com/en/diagnostic/ecu_10649.html

http://training.avme.net/admin/Uploa...20generell.pdf

[Meat-Head]

Weird sounds like TWO at least seperate faults.

[genius76]

Weird sounds like TWO at least seperate faults.

01844 Control Module for Fresh Air Blower
03023 - Running-in Requirement No or Incorrect Basic Setting / Adaptation


Ofcourse firs always wiring wiring late wiring an again wiring my opinion that adapt. or basic settings is losing if not se fan motor or similar

[Meat-Head]

my opinion that adapt. or basic settings is losing if not se fan motor or similar

FFS WTF a heater motor that needs 'basic settings' no wonder Hitler lost the war, army was too busy looking for places to hide screws and programming their Messersmits

[electrones]

01844 Control Module for Fresh Air Blower
03023 - Running-in Requirement No or Incorrect Basic Setting / Adaptation


Ofcourse firs always wiring wiring late wiring an again wiring my opinion that adapt. or basic settings is losing if not se fan motor or similar

Thank you m8s

genius76/

Meat-Head
Some dtc is solved, the fan is already running " Haven?t power(12v) in J126 "
Now i need to make adjustment has already made ​​a few attempts but without success.

I need finish it, i have VCDS, remains resolve this error 03023 - Running-in Requirement No or Incorrect Basic Setting / Adaptation.What is the channel for adaptation; procedures please?

Cheers

[genius76]

Tray look here sorry for inferior Audi-Resource - Climatronic

[electrones]

Hi genius76

Again your help was crucial in resolving this problem thank you so much friend "My Genius". after reading the "audi-portal" did the configuration on channel 001/003 ready "A/C works 100%"


Cheers

Audi Portal: ECU Diagnostic . Audi Q7 4L (2007- ) . Climatronic J255