Hi,

I've got a DM500s with a 4x1 DiSEqC-switch. When I try to change channel to a channel on a different LNB. The screen just stays black and the signal is at ~60%. When I change back to the channel I were on, it still works perfectly. When I restart the reciever or sometimes just switch channels back and forth the channel starts functioning as it should. But then the other LNB doesn't work, and I have do the same procedure over again.

I suspect that the communication between the receiver and the switch isn't as it should be. So, is there any settings you can change to make the switch work properly so you don't have to restart everytime you change LNB? Or do you know any other way to make this work?

Thanks in advance,