xentry and 204

[zsolty_szasz]

Hi,

I installed a couple of weeks ago Das 07/2012. I have C3 multiplexer. Das is working good but when I connect a 204 series Xentry don't work. I open Xentry then after car selection I can see the Voltage but later after finishing scanning the modules voltage disappear and xentry keeps telling me that I should put the ignition ON -all the time- and I have no communication with all control units.

Does anybody encounter this error?

[DB_member]

Have you applied the Xentry blacklist fix? Which MY 204 is it, have you tried to diagnose it directly from DAS?

[zsolty_szasz]

As I told you Das is working fine with all cars except 204, 212 etc. which are suppose to work on xentry. But they are not working on Xentry - xentry says no comunication with mumtiplexer after a while (after loading by those steps) and no ignition and no supply. Because of this I cannot comunicate with the control modules.

[DB_member]

You said DAS is working fine, you did not say it is working with all cars.

You could have tried to diagnose the 204 from DAS as I told you but if you don't want to do it (or if you don't know how to do it), I wish you luck with the issue. You already got the instructions for the likely fix.