How to read Delphi Delco MT35E?

**ricked** · 6th May, 2020, 11:01 AM

Originally Posted by henal

everything is connected correctly to pin numbers, can you tell me what you see wrong ? either im being a noob and doing a mistake ?

if you dont see it i cant help you, also where is connector to casing ground?

start over and connect it as per link i did post

also what tool/software you use to read this ecu?

**henal** · 6th May, 2020, 11:19 AM

Originally Posted by ricked

if you dont see it i cant help you, also where is connector to casing ground?

start over and connect it as per link i did post

also what tool/software you use to read this ecu?

all connections are good, i did everything correctly.

**henal** · 6th May, 2020, 11:21 AM

Guys all done,

for his vehicle it requires K line and not CAN,

tested both ECU and both have communication with K Line connected.

Vehicles K line has failed going to investigate it. since i couldn't connect to IMMO ring aswell

**volorucinski** · 6th May, 2020, 03:58 PM

Yep. That xep mt35 works with immo 2 with UN 13144390. Ecu must be version 2.1 FFFR 12942893... Henal, i think your post should start with this codes i wrote here, and job was much easier...

**henal** · 6th May, 2020, 08:05 PM

Originally Posted by volorucinski

Yep. That xep mt35 works with immo 2 with UN 13144390. Ecu must be version 2.1 FFFR 12942893... Henal, i think your post should start with this codes i wrote here, and job was much easier...

spot on man, fixed the car stupid UN Ring failed which causes the ecu to cause no comms, replaced the immo ring and all done,

**volorucinski** · 20th June, 2020, 06:03 AM

Hello, Henal. Question: doo you still have the full flash read with Carprog, for tihis xep ecu type?

**death9891** · 11th August, 2020, 02:06 PM

Carprog v05.77 has functional flash buttons for MT35E -CAN recording.

But it doesn't work flash write

**henal** · 17th August, 2020, 10:11 PM

Originally Posted by volorucinski

Hello, Henal. Question: doo you still have the full flash read with Carprog, for tihis xep ecu type?

unfortunately i dont since since when it worked, i just fixed the issue, did have a spare one but i sold it, what you need help in.

**ziomski** · 5th December, 2020, 10:12 AM

I use FVDI for this unit.

**volodin69** · 5th December, 2020, 12:16 PM

Originally Posted by ziomski

I use FVDI for this unit.

Hello, does it get full flash and does it write back?

**ziomski** · 9th December, 2020, 07:44 PM

Originally Posted by volodin69

Hello, does it get full flash and does it write back?

Its partial read, yes it write it back.

**RevotronicACS** · 13th December, 2020, 02:55 PM

wich immo deprog did you used

**kashalot** · 29th March, 2023, 05:36 PM

Today I had to read the security code in a Zafira B Z16XEP Delco MT35E car.

FVDI couldn't handle it, Car Prog 8.2 handled it over the diagnostic connector without a problem, however the ECU had to be matched with an IMMO.