Hi all
I need help with a mazda 3's airbag control unit. I tried removing the crash with carprog, but the control unit had various problems after that. Now I'm not sure if carprog read the original content right, or it just couldn't remove the crash correctly. Can someone verify for me, or remove the crash again? I also tried some else's dump (same part number) without the crash, but now I'm also getting configuration errors. Or if someone could upload a working dump I'd also be grateful.
Airbag ecu is: Bosch 0285001554
EEPROM is: 95080
Any help is welcome.
Results 1 to 3 of 3
Thread: Mazda 3 Airbag crash
-
19th May, 2014, 06:23 PM #1DK Veteran
- Join Date
- Feb 2011
- Posts
- 477
- Thanks
- 186
- Thanks
- 53
- Thanked in
- 44 Posts
Mazda 3 Airbag crash
Last edited by ACDC; 19th May, 2014 at 06:26 PM.
-
20th May, 2014, 09:03 AM #2DK Veteran
- Join Date
- Apr 2010
- Location
- tukey izmir
- Posts
- 540
- Thanks
- 278
- Thanks
- 330
- Thanked in
- 195 Posts
hello
Please try reports
-
The Following User Says Thank You to muratasutay For This Useful Post:
ACDC (21st May, 2014)
-
22nd May, 2014, 07:09 PM #3DK Veteran
- Join Date
- Feb 2011
- Posts
- 477
- Thanks
- 186
- Thanks
- 53
- Thanked in
- 44 Posts
I've tired muratasutay's dump, and the airbag ecu works fine for a while, but then it starts showing an internal fault. Does anyone know what could be the problem? Should I write the eeprom while on the pcb? Or can I write it while it is desoldered from the board?
Reply With Quote
Bookmarks