Hi all,

trying to desolder the 5p08c3 eeprom from an EDC15C2 because of the limit of 50 error delete, i damaged the memory and lost all the data.

I was using hot air, like all the other times, but this time a little corner of the eeprom went away....

I have an other 5p08c3 from an other edc15, I've desoldered it, read, programmed all ff, soldered in the ecu.

Car now starts, but I have a few errors (auto gearbox, esp, ecc) and the DTCs of the configuration missing.
I made the configuration with the PP2000, but it can't save the configuration in the ecu.
So i tried the configuration of the ecu like it was new, but the PP2000 says that the ecu is already coded.

I found an eeprom reading from a psa edc15c2 here in the forum, but I don't know if it would be a good idea to try that dump...

I've 2 immo programs, too: one to switch off immo from the flash, and the other to switch it of from the eeprom (but says 95080) and a "edc15 PIN PROGRAMMER - after the programmin the pin is 1122"


Any help apreciated



Peugeot 607 2.2HDI 133cv Auto Trans.
bosch edc15c2
HW 0 281 010 567