EDC15C2 PSA - damaged eeprom - configuration lost

[matech]

Hi all,

trying to desolder the 5p08c3 eeprom from an EDC15C2 because of the limit of 50 error delete, i damaged the memory and lost all the data.

I was using hot air, like all the other times, but this time a little corner of the eeprom went away....

I have an other 5p08c3 from an other edc15, I've desoldered it, read, programmed all ff, soldered in the ecu.

Car now starts, but I have a few errors (auto gearbox, esp, ecc) and the DTCs of the configuration missing.
I made the configuration with the PP2000, but it can't save the configuration in the ecu.
So i tried the configuration of the ecu like it was new, but the PP2000 says that the ecu is already coded.

I found an eeprom reading from a psa edc15c2 here in the forum, but I don't know if it would be a good idea to try that dump...

I've 2 immo programs, too: one to switch off immo from the flash, and the other to switch it of from the eeprom (but says 95080) and a "edc15 PIN PROGRAMMER - after the programmin the pin is 1122"


Any help apreciated



Peugeot 607 2.2HDI 133cv Auto Trans.
bosch edc15c2
HW 0 281 010 567

[ominimicu]

i Once broke a immo eeprom on sang yong rodius..just like you and it still worked!

Anyway tehre is a lot of config inside there...i recommend getting dummp from similar ecu and immo off-well that pin programmer 1122, and after that you can recode keys using that PIN

[matech]

I found here: http://www.digital-kaos.co.uk/forums...-607-a-262485/ a dump of the eeprom from en ecu of the same HW, but different sw realese.

What program can make the dump virgin? One of mine make immo off from flash, the other from a "95080"...no virgin solution...!?

[Meat-Head]

there is more than one thread with Vergin EDC15 dump, use the LEECH function.

[matech]

ok, problem solved:

made immo off on a dump found here on the forum (same HW) and now car starts, and i were able to recode the configuration.

no need of PIN code...

but the 50 errors delete limit is still there :-(

[Meat-Head]

OK, there a rumor that states if you read and reprogramme FLASH on EDC15C13 it then recode injectors, it removes speddd limiter.

Try reading then writing the flash, see what happens.

If you report back stating wheather that worked or not depends if i direct yo to the threads with the VERGIN dump in them!