need help to program remote peugeot 406

[spider2004]

hi friends

the car is peugeot 406 2003

the transponder inside remote was lost
after i programmed a transponder ,started the car ok.

but the problem that remote stop working .
i tried several ways to program it but failed.

i switch ignition on pressed big button twice but faild

also i switch ignition on press and hold big button 10 sec and faild

please help because remote is dead and customer is very angry(he wil come back again tomorrow)


thanks in advance

[Carkeysa]

Hope this helps;

406 & 605

The 406 deadlocking remote control has specific buttoncontrols, and if the vehicles has two controls, one is set as primary and theother as secondary. When replacing the Plip, a Primary or Secondary Plip are different part numbers and mustbe ordered as required. The white label inside the Plip is labelled PRIM andSEC.
Procedure
1. Turn the Ignition switch ON.
2. Press the large Plip key button(Primary Plip)
3. Within 10 seconds, press thelarge Plip key button (Secondary Plip)
4. If there is one remote, pressthe Primary plip button twice.
5. Turn ignition OFF.
6. Test Plip for correct operation.

NOTE : On some 406 models, Plips cannot be re-synchronisedunless the battery has been disconnected for 1 minute.


406 (D9) 2001 >

Procedure
1. Press and hold large button andthen press and hold the small button for 20 seconds.
2. Release both buttons, the indicator light on the plip will illuminate.
3. Press the large button once andthe light will go out.
4. Switch the ignition ON for 3 to 5 seconds.
5. Switch the ignition OFF and remove the key.
6. Lock and Unlock the vehicle with the remote to test.

[Zmann]

maybe this thread answers you