Hi all,
who please have X-prog M 5.5.0. ori. But after update sw from older version to 5.4.8 with reflash inside mcu in HW. I have problem with tool for Micronas dashboard.
When I try read data: Odo, VIN, PIN Micronas tool bypass with sucess security, but in end of this procedure write only ...idle and all small windows go out and only one stay, but is empty.
Before this update all work very well. I must change values in other tool and after change write back to device.
But is complication. Old way is faster.
Who have please the same problem.
I send info about this to Dariusz, but without feedback.
So I have only one feedback. Dariusz say to me if is possible when I have one from cables inside broken procedure won?t work.
I make new ISP cable for this adapter. All other MCU as Motorola 9S12, etc work with this cables well, Micronas too. R/W/V all work. Only tool is in SW bad.
Many thanks for answer and sorry for my bad english. :-)
Best regards ans have a Christmass days.
Matias
P.S. I hope if is this thread in good section. :-)