***Toyota Smart Lost Key Solution - No Id code needed***

[tafadzwa]

can you please help, i cant seem to find ECU ID CODE for Toyota Ractis 2007 model, can anyone please help me locate this ecu

thanx in advance

[aboazam]

you must program key in smart key unit then set key in car then jumper obd 4 with 13 line then you must open switch with fuse box for 45 minutes then car will start. if you need file for epprom smart key and Id code unit say thanks if I helped you

[autokeypro]

you must program key in smart key unit then set key in car then jumper obd 4 with 13 line then you must open switch with fuse box for 45 minutes then car will start. if you need file for epprom smart key and Id code unit say thanks if I helped you

Please elaborate on open switch with fusebox?

PM

[aboazam]

set this file at smart unit and Id code unit dont forget program key at smart do that

[autokeypro]

set this file at smart unit and Id code unit dont forget program key at smart do that

aboazam

the file you shared is 93C46. Our IC is 93C56.

[AjDaBeast]

smart ecu 89990-53382
93c66 ssop
akl advice appreciated.

[AjDaBeast]

Solved and Thanked

[wokolomo]

so from running through this thread, my understanding is...for a lexus IS250 2008 push start brought in with 1 immo chip (not sure if its master or valet, only used to start the car by touching on the button, because proximity key is missing), best way forward is to:

1) remove Smart ECU from trunk
2) then remove ID Code box from dashboard
3) then virginize both chips within each ecu
4) short pin 4 and 13 on obd for 30 mins to re-pair ecus
5) pair new proximity key fobs with techstream?

Am i understanding this correctly or is there a simpler solution?

any help is greatly appreciated!

[immoresearch]

Solved by adding key on table?
how did you solved please
i need to add hey on table or virgin file for 2015 highlander 93c66

Solved and Thanked

[Nourain Tech]

so from running through this thread, my understanding is...for a lexus IS250 2008 push start brought in with 1 immo chip (not sure if its master or valet, only used to start the car by touching on the button, because proximity key is missing), best way forward is to:

1) remove Smart ECU from trunk
2) then remove ID Code box from dashboard
3) then virginize both chips within each ecu
4) short pin 4 and 13 on obd for 30 mins to re-pair ecus
5) pair new proximity key fobs with techstream?

Am i understanding this correctly or is there a simpler solution?

any help is greatly appreciated!

Yeah it is correct procedures go a head


Sent from my iPhone using Tapatalk

[tafadzwa]

please share the virgin files for lexus is250 um also working on the same car, it can only light the dashbord on but without cranking

thanks in advance

[spope]

Hi,
Please my cousin forced my car key out of the ignition and in the process, the remote opened and I think the sensor probably fell out as we cannot start the car since then even after cutting another key. Can anyone help me in resetting the master key?
I drive a Toyota MArk X 2007 GRX1203014391

[wokolomo]

Thanks for the input, I will try these steps. Just thought it would be able to find faster or simpler way. A bit lazy to remove dash to get to ID box...

[wokolomo]

Yeah it is correct procedures go a head


Sent from my iPhone using Tapatalk

Thanks for the input, I will try these steps. Just thought it would be able to find faster or simpler way. A bit lazy to remove dash to get to ID box...

[K1nd3r]

toyota sienna smart system have something special that i can not reset peps, lonsdor, obdstar fail, usa market