Key system or proximity?
Key system or proximity?
Did you try looking for it behind blower? Not possible to do immo off as I know.
Found immobilizer after removing dashboard. Behind center blower louver (a few cm below windshield) mounted to firewall. Cannot miss it as there is a wire harness...
Immo part number is 89780-71030
Anyone can help reset this so I can add the 2 oem keys. Thanks.
Last edited by Hanukkah; 17th April, 2014 at 01:18 PM. Reason: added few details...
gordonjairo (18th August, 2014)
Great. Can you please kindly take a pic of the location?
As for the immo, we will have to wait for our expert. I think you will need to post key data.
ya a picture will be great and the part number
ready to add key
Here comes our expert. Hahaha
Thanks gwee...
BTW, what is procedure for adding key?
Last edited by Hanukkah; 17th April, 2014 at 01:37 PM. Reason: typo
you will need key with pg1 - 36 or 56.
if u are adding 2 keys, i think first u have to insert first key, wait for few seconds then pull out,
insert the second key and turn ON OFF 5 times quickly to close the learning mode.
Hanukkah (17th April, 2014)
If it is like usual, the immo light should stay on when you plug in the immo box. As you insert the key, light will blink once and continue to stay on. Insert another and it should blink again. After closing the learning procedure, light will blink like normal. Not sure if it is the same for this car.
Hanukkah (17th April, 2014)
Many thanks gwee and iamfooser...
Will do this tom and report how it goes.
Thank you brothers =)
Try an report. please disconnect the immobilizer or cut communication to the ecu immo
pass: mp
Hanukkah (19th April, 2014), rtbdiagnostic (8th January, 2021)
Bookmarks