caterpillar flash file editor

**whalla** · 25th April, 2014, 02:28 PM

hello does anyone have a caterpillar editor comparable to calterm or ddct.
Need to change hp and cooling fan temperature settings

**MommaBurt** · 9th January, 2015, 08:55 PM

anyone know of any software like this free or not free?

**drewwarhard** · 28th January, 2015, 04:37 AM

try copying the ecm replacement file then open it in the notepad or internet.xml. you can change code then resave then upload on et then send to ecm.

**jctech** · 5th February, 2015, 06:03 PM

The ECM replacement file does not contain the flash file, onle engine/machine specific parameters

**ukrainiandisel** · 15th December, 2016, 07:57 PM

Originally Posted by drewwarhard

try copying the ecm replacement file then open it in the notepad or internet.xml. you can change code then resave then upload on et then send to ecm.

One time I try to make this, but then I try to reupload to ECM I have a return by system and message like a impossible to load file, file is damaged or not authorized. If this is config file better to change parameters that you need after upload to ECM or run ET offline, load file for redactions than change the parameters, and than upload

Отправлено с моего iPhone используя Tapatalk