Reply With QuoteJust follow image and on screen instructions.
Click connect on fgtech sw as you did, then power on the ecu with the bootpin connected and hit OK on the dialog.
Just that.
Results 1 to 5 of 5
-
1st July, 2014, 06:24 PM #1DK Veteran
- Join Date
- Apr 2010
- Posts
- 3,560
- Thanks
- 885
- Thanks
- 379
- Thanked in
- 309 Posts
VAG EDC17CP14 boot mode with galetto 2
Hello!
Can you give me a step by step instructions for put this ECU boot mode with galetto?
I wired ECU, give 12V adapter to galetto solder 1000ohm resistor to boot pin. Choose the SAK-TC1796 Boot mode.
When I click connect after galetto only asks me to remove and give feeding to ECU before continue. Nothing about when connect the boot wire to bootpin like older ECUs like MM ST10xx or Siemens infineon C167
-
1st July, 2014, 07:13 PM #2DK Veteran
- Join Date
- Jun 2013
- Location
- EU
- Posts
- 4,125
- Thanks
- 1,339
- Thanks
- 2,639
- Thanked in
- 1,528 Posts
-
The Following User Says Thank You to morgano For This Useful Post:
Fec001 (2nd July, 2014)
-
1st July, 2014, 07:21 PM #3DK Veteran
- Join Date
- Apr 2010
- Posts
- 3,560
- Thanks
- 885
- Thanks
- 379
- Thanked in
- 309 Posts
I did that and after some time it asks the same again " Remove and give feeding to ECU before continue"
The resistor is only 980ohm, is that could be problem?
EDIT:
Solved. In my PDF CAN Low is seems yellow. I saw on yours, it is orange.Last edited by Fec001; 1st July, 2014 at 07:27 PM.
-
2nd July, 2014, 01:04 AM #4DK Veteran
- Join Date
- Jun 2013
- Location
- EU
- Posts
- 4,125
- Thanks
- 1,339
- Thanks
- 2,639
- Thanked in
- 1,528 Posts
Yellow is L-Line
-
6th April, 2020, 10:43 PM #5Newbie
- Join Date
- Jul 2018
- Location
- Norge
- Posts
- 18
- Thanks
- 7
- Thanks
- 1
- Thanked in
- 1 Post
IMG_20200406_233030.jpg
I have the same problem, can anyone help what should be put down?Last edited by spec jarek; 6th April, 2020 at 10:50 PM.
Bookmarks