X-PROGm no read, help

[diyre]

Hi all, I have a X-prog 5 Every time I try to read some motorola MC68HC05xxxx, the zocalo 1-001-001 asks me which I do not have and can not find.
I have 1 like and use it to mount the micro, with the information of the pins, the programmer amount in the small connector 5v, grn, b1, b2 ......
By giving read does nothing ...
There is another adapter that gives you the option of putting up the same 5v, grn, D1, D2 ......, according pinout put it and nothing. Under the photo as is, up to 10 minutes so it stays, if not cancel does nothing.
Someone passing something or know you can be?
a greetingx-prog2.JPG

[audivwauto]

go settings ,environment and check port settings

[gyapi11]

Hi.I have the same problem. What is the solution?

[diyre]

hello, thanks for your answers, the COM port is correct, detects the interface. Before not detected and I said "silent device" or something, and now detects when going to read does not do anything, just turn on the green light as giving the order and can take a long time as well.
a greeting

[alfons37]

Try resolder motherboard

[whiskeyman]

put chip in hc05 adaptor
make sure legs are clean

make sure chip in proper position in adaptor

should read no problem

[diyre]

Hi, I already did, but the adapter have to do with bridges. I order the adapter 1-001-001, which do not have or encounter any site. I put direccto to the machine and through a 1-002-0008 adapter. 2 ways to do the same thing. They know where I can econtrar the correct adapter?
a greeting