Opel Vectra 3,2 Bosch ME3.1.1 pinout

[Hpmengine]

Hello friends, I have a problem, I would like to read the flash of this ecu:
Bosch
0261208049

Does someone know how to do it? I'd appreciate your help


regards

[boxsport]

Hello guys,
I´m also having an ECU like this and i would need to wire this on bench to see if i can read the pincode...
I need to adapt this ecu to another car, but i have no pin code or VIN from this ecu.
Can anyone tell me how can i read this ecu on bench?
does anyone know if FVDI 2018 can read this?
Thanks

[boxsport]

i was able to read "Info Only" on the ECU i have using the connections:
Connector "X86" pin 15,16,31,32,47,48 +12v, pin 12-CAN-L, pin 29-CAN-H, Pin 20 Ground (and Ground in ECU Case), Pin 53 K-Line
Note: These connections came from another post here in DK (https://www.digital-kaos.co.uk/forum...=1#post2663842 )
But this only worked to read ECU "Info" with FVDI 2018. I was not able to read ECU Dump with Kess or CarProg (using fiat/alfa protocol Bosch ME 3.1)...
It turns out, this ECU is not from a Vectra. Its from a US Car Model "Saturn", but it was sold as a "Vectra 3.2L ECU.

So i need to see how can i read this ECU and check if this would work to adapt into a 3.2L V6 Vectra C...
If anyone can help i would really appreciate.

Thanks

[TricoreMan]

Did you have any success with that?

[boxsport]

With these ECUS, i was able to get OP-Com Advanced to read ECU Pin code and reset...
But this only works if there is no "waiting time" in the security.
If for some reason ECU is "locked" with waiting time, i was not able to Reset even if i have good pincode.