Hello.
Can you share ept file for FTDI chip? I reprogramed atmega via TL866A but unfortunately "device is silent"
When I conncected to MPROG3.5, my FTDI is blank.
I tried put EPP to 93c46 but my TL866A cant read and write this chip.
thanks a lot.
Hello.
Can you share ept file for FTDI chip? I reprogramed atmega via TL866A but unfortunately "device is silent"
When I conncected to MPROG3.5, my FTDI is blank.
I tried put EPP to 93c46 but my TL866A cant read and write this chip.
thanks a lot.
where to find adobe reader 10?
Youneselm (4th January, 2017)
Show me tell me the program window is unregistered and shows the status bar and then says there is a error please help me
Last edited by aliali12; 16th February, 2017 at 12:05 PM.
Hi,
can anyone tell me how to connect beeprog+ to xprog and how to configure fuse for programming it ?
Thank
Anyone know how to set Fuse and lock on Orange5.
I have managed to update it to 5.5.1 with success i have all the authorization i tested HC11 and tried to read it as MC68HC11E9 with security bit i get an error message that says "XPROG-m hardware supply voltage too low Check XPROG-m power supply" anyone experienced this issue after an update??
successfully updated update.JPG
Low voltage errorerrors.JPG
Fuse for orange5 if someone needs themXprog_M(fuses).jpg
Last edited by Ahmy501; 29th April, 2017 at 11:21 PM.
Ok, I need help.
I had this software working fine in my computer and my HDD failed.
I had a friend install new HDD and had lost all my programs and files.
I am trying as I did before to install and wont work. I have box all setup but I can seem to
get my computer to install FTDI drivers.
I have tried almost everything... Anyone with advice?
Is this LA's version or a differnt one?
Hass42:
go to original xprog site and dowload drivers.
Last edited by narkeleptk; 23rd June, 2017 at 05:41 AM.
Hello guys,
I have problem updating my Xprog 5.0 to 5.5 ,I think I do somting rough with following steps,right atmega,set fuse box,right flash,program lock bits.I try to wrought Atmega64 with upa 1.3 without error.
Can someone guide me witch are exactly are the steps to get back to work my xprog?
Regards,
If I help you dont forget to push thanks button
Hi To all....
im new in this job and i recive my first box Xprog-m v5.72 Cloned .
the problem the box ask for ""x_requstion_file .dat "" we need to pay for this activation or what ?
taxo1965 (16th January, 2018)
You can lay out the software V5.72?
let me slove my probleme and i will opload it OK !!
Bookmarks