Are you kidding? Sure he can... He was able to copy it and paste it here, everything else is peanuts for him.
i have problem.i have xprog 5.0 clone. i install on win7 x 32bit, adobe reader 10. update ok. run error : unknown command. Software error. How to soved?
paulocesar (28th June, 2016)
problem solved. it work good
can i update xprog m with programmer tl866? its have atmega64 but i not know how to connect
Someone could help me with lock and fuse bits ?
I tried to program ATmega with usbasp programmer
Screen from bascom
tested on line, internet 100% smoothly.
Galee (12th January, 2017)
hallo, I have installed the new firmware 5.5.1 on clone
but when I start the software gives me all blocked
All works ok cas 2 cas3 read and write in first time Thank's Good job.
files are removed?
regards
audiotek (28th December, 2014)
Bookmarks