FORD TRAVELPILOT OMAP5948+S29GL256N(BGA) how to read external flash

**zalupentiy** · 16th April, 2015, 06:21 AM

This units have other problems.
There broken some chips...
Problem are solved. Flash file will not help you.

**tehnosoftex** · 16th April, 2015, 09:11 AM

Originally Posted by zalupentiy

This units have other problems.
There broken some chips...
Problem are solved. Flash file will not help you.

And what are these problems? Ive seen several units which didn't start any more, and if I heat up the flash and I power up the unit while the flash is still hot the unit start and run ok. If I remove the power , and apply again when the bga is could the unit is dead again.
I think the flash can be read with jlink but need a proper project. Ive tried to make a project and manage to read only some blocks of flash but the program is disconnecting often. I manage to read and write the flash with a programmer used for jailbreak the PS3, progskeet, but need allot of wires to connect.

**shorttrader** · 6th May, 2016, 12:49 PM

Originally Posted by tehnosoftex

And what are these problems? Ive seen several units which didn't start any more, and if I heat up the flash and I power up the unit while the flash is still hot the unit start and run ok. If I remove the power , and apply again when the bga is could the unit is dead again.
I think the flash can be read with jlink but need a proper project. Ive tried to make a project and manage to read only some blocks of flash but the program is disconnecting often. I manage to read and write the flash with a programmer used for jailbreak the PS3, progskeet, but need allot of wires to connect.

I have purchased new GL256N Chips now. But I did not have the original Dump from this chip. Can somebody sell a dump to me?