MORS77 (24th June, 2020)
MORS77 (24th June, 2020)
Hello!
I had 2 strange situations with vvdi prog.
He kills 2 Mcus after read flash.
One in Vito Eis with 1L02M and one in Ews4 from X3 with 2L86D , both secured Mcu. The situations is the same, after read flash the eeprom is erase ,all FF and can't write again.
I changed Mcu and write with R270 to solve the problems. Question? My vvdi is damage or is sw bug? Anybody have the same isues?
Regards
I've got problem with write of MCU SPC56AP54L3. VVDI prog reads ID of my MCU like ID 1DC0E2070000000
Read is OK but it cannot write.
VAG
ASCM (12th July, 2020)
hi mates,
does anyone was a pinout reading with vvdi prog an I40 mcu MB91F062? I had contacted Samic the developer of vvdi prog but i never get any support or at lest an answer from them. They only sends link text to buy more product from them but will never give you any support for the tools they are selling....
MB91F062.jpgMB91F062 I40.JPG
Tested pinout for Jeep Grand Cherokee / Chrysler 2015 BCM.
Jeep_Grand_Cherokee_2015_BCM.jpg
Jeep_Grand_Cherokee_2015_BCM_1.jpg
brodaty (17th August, 2020), duzi (17th July, 2020), habbyb (18th July, 2020), hivrich (19th July, 2020), immoneard (6th August, 2020), KADE007 (19th July, 2020), PocketHero (18th July, 2020), ricked (17th July, 2020), s qubiak (19th July, 2020), Tariel (7th September, 2023), taxo1965 (18th July, 2020), ypiter (17th July, 2020)
IF I HELPED YOU, PLEASE REMEMBER TO PRESS THANKS AND REPUTATION.
hivrich (19th July, 2020)
Volvo CEM pinout
M68HC912D60 mask 0K75F
unsecured bcose the shadow is FF
Sir, are you classified as human? Negative, I am a meat popsicle
datapage (11th October, 2020), igorr (21st July, 2020), kumistheru (20th July, 2020), rob h (21st July, 2020)
So, are we going to see Freescale Motorola HC11 in this tool or we will have to use good ol' Xprog forever?
Fiat Sedici immo
MC68HC08AB16 Mask: 0L72A
lift the marked pin-s and use the attached picture to setup the vvdiprog
Sir, are you classified as human? Negative, I am a meat popsicle
hi,i did try to read and clone dashboard from ford cmax 2006 ,reading eeprom flash and eeprom "ok" ,but when i write eeprom and flash to same another dashboard write ok,but after that test on car ignitio on nothing on dashboard not start not immo ligh on,i try one more time same on 3rd dashboard same thing before write dash working,after writing with vvdi dash die,why? what can be problem?vvdiiiiiiiii.jpg
Bookmarks