Hey guys, it looks like I have something extra again.
I read the 0D60J (HC05B32) chip with XPROG-m, but I have one 0 at the place where the code should be. What does the 0 translate to? I tried reading it in different adapter, but I got the same content from chip.
My unit looks like this:
And the code is here:
Thank you for any info.
Last edited by bajticzek; 23rd August, 2015 at 01:34 PM.
Meat-Head (30th September, 2018)
@Autoelek your PIN CODE is 92970 100%...try and report
@Bajticzek your PIN CODE is 93900 100%...and you to mate, try and report
Best Regards
autoelek (27th August, 2015)
What did you use to read HC08?
Dumps are all wrong...
I tested code and car was accepted this code, I confirm that code 92970 is good and matched to file "hc05=2015-08-21.rar" which I was attached in previous post ! THANKS mikajna
Last edited by autoelek; 27th August, 2015 at 07:38 PM.
mikajna (27th August, 2015)
My mistake,HC05.
Dumps are shifted,must be reading bug.
If we shift them two positions backwards one pair we get correct position for pincode.
I guess that is why you have two extra 00 in the beginning of your dump.
mikajna (27th August, 2015)
mikajna and simaservis1108 - Thanks for the answer. I will test the code today and report. It makes sense the positions are wrong - it really looks like the code is shifted by one word.
Ok, so the code is not working. I login via AlfaOBD with code 93900, I try to store new remotes and AlfaOBD immediately says the code is wrong, so the unit doesn't accept the procedure... Should I buy UPA to read the chip? I have XPROG-m, as I said earlier, so maybe the reading via this was wrong... I also have CarProg 4.01, do you think this box can read the HC05 without any problem? Or should I buy the UPA and don't risk messing the chip with CarProg?
Best is ETL.
I have for every MCU family.
Never had any problems.
Sent from my iPhone using Tapatalk
Mate I just check your whole dump from image you had post here...and your dump is not good, maybe is because programmer which you used, as said mr.Sima, really I dont know, just know that row 00000060 must have fixed bytes, not all but almost all...and your dump dont have it.
Read that MCU again, and post here dump...than we will see is problem in reading or mcu is corrupted
Hi
I have problem with my dump. The pin it's 71609 but it not working. I read mcu with xprog. Maybe I doing something wrong. Can somebody check my dump and write the correct pin?
dump 156.rar
Thank mikajna for check this file. I have only xprog. Today I check this code with examiner maybe it's work. I try only with AlfaObd and no succes.
Bookmarks