Anybody know, why my CP after select some function in cp, ( eg. edc16 vag ) disconnect from usb ? Sounds like cable unplug. I dont know why, cable OK, tested on 2 pcs CP.
Anybody know, why my CP after select some function in cp, ( eg. edc16 vag ) disconnect from usb ? Sounds like cable unplug. I dont know why, cable OK, tested on 2 pcs CP.
For ECU VAG A1+ adapter must be connected
Sent from my JSN-L21 using Tapatalk
hallo does the clone china carprog 8.21 online will works 70% of original device,i need it only for airbag,thanks all for help,how much it cost the original device from where i can buy it
ali lbl (23rd November, 2019)
Hallo friend where I can buy it the EU clone carprog,do you know how much it cost,thank you very much
you found ?
hi all friends i need to rework my device so i dont have MM74HC128M in my area but i have MM74HC14M so i need electronics men advice me about if are compatible am not electronic specialist.
please help me brrs i wont to damage my device.
Tried to get radio code from vw technisat by using my original carprog, it failed, I get "read error"
If i read the eeprom under the eeprom menu 24c16, it reads fine and i get dump. but cannot get the code.
any ideas?
Hello Mates.
Can do rework on clone CP V10.93 offline version?
Hello
Any one have lucky reading carpass in opel vetra C ?
Which version you used for it ?
Regards
Enviado desde mi iPhone utilizando Tapatalk
Yes by eu clone
https://youtu.be/Ez-rMlgPGtY
Sent from my JSN-L21 using Tapatalk
nexusjose (24th January, 2020)
Hi,
Test some one if can in one clone carprog unit to writhe the one valid serial know from one original unit carprog and after to use it the clone unit like original with internet update ?
First off...thanks to all who have posted in this thread.
I've reflashed my clone carprog with both the v4.47 and v8.21 at the beginning of this thread but when I connect the mcu to my computer and launch the carprog software the device is not recognized. I do not have usb human interface listed in device manager either. I've tried with both the 12v external power connected and without. The corresponding lib file from this thread is in the same folder as carprog.exe
When reflashing the mcu I did not remove the at88 chip since the latest tutorials I found said there was no need to remove it.
If I erase the mcu and connect to the computer the computer recognizes that something is plugged in but cannot identify it.
I've tried multiple usb cables and multiple computers all with the same result.
Is this a sign that either the at88 chip is corrupt or erased or maybe the mcu is dead?
Does anyone have any suggestions to try to bring this back to life or should I just buy another mcu and start over?
Thanks.
Bookmarks