bad read of donor ecu , try to read again
Hi Guys.
Audi Q7
3.0 6 Cyl
Diesel
Automatic
BOSCH EDC16 ECU
Short story is....
ECU Water Damaged. Bought another ECU from Smashed Vehicle. Car will not start. Instruments show SAFE and ECU DTC Scan it shows CRASH SHUTDOWN ACTIVATED.
Tried to move eeprom 95320 from old ECU to new (Donor) ECU but car would not crank. DTC show "ECU not Coded or incorrectly coded".
So can somebody clone the original eeprom to the new one. Obviously we need to keep old VIN but odn't want the new eeprom because it has a permanent DTC of CRASH SHUTDOWN ACTIVE.
Here are the files from old ecu and new donor......
Thanks guys
Last edited by obeids; 12th August, 2015 at 06:06 PM. Reason: Updated Donor File
bad read of donor ecu , try to read again
Hi
for the correct job you have to write flash+mpc+eep contempt from original to donor ecu ! also check if both ecu are with the same label
Mike
Full WinOLS user
Custom ENG/GER OLS file for Tune /DPF / SCR / EGR / TVA / VSA / DTC and more...
Readout from new ECU is bad
VIN: WAUZZZ4L47*035*81
CS:40CA6754819400
MAC:C0DF1E08
PIN:37703
Good luck!
Last edited by eliasole; 13th August, 2015 at 07:13 AM.
Hi
So do I just write this eeprom with xprog and it should work?
No coding or adaptations needed?
YEAP!!.............
onejay10 (1st October, 2019)
How did you repair this eeprom @eliasole ?
post your damaged one
post here dump oryginal and donor. if oryginal dump not damaged, sometime enough rewrite oryginal file and ECU coding, sometime enough only rewrite, and work
Last edited by yarowsc; 1st October, 2019 at 05:23 PM.
Hi change org old ecu eeprom to new donor ecu epprom chk ok test and report
2 file immo off
login 40915
Last edited by tothzsolt; 1st October, 2019 at 05:43 PM.
Bookmarks