Ask smok for English translation
Hello DK,
I am new here, just bought Smok tool and it will arrive at the end of this week hopefully. As you seen in my other thread I am a bit worried about the PDM/DDM Jtag on Volvo.
As I am new to this I need someone to help me doing it the right way. In the picture/Text that is provided by smok its unclear where i should put the Jtag wires. And its also polish language which I do not understand, when i put it in translator it makes no sense.
Is it possible to pay someone to make a guide, with pictures and complete procedure in one of this languages: English/Swedish/Serbocroatian? Or is there a guide already done online?
Seems like im the only one who doesnt know how to do a "easy operation" like this...
Thank you
Ask smok for English translation
Oh and by the way if my post has been at all helpfull
please press the little THANKS tab
First read dashboard eprom and make backup and of course make new km and after that change km in PDM /DDM
Read on OBD PDM / DDM eeprom and flash
On new model (2014/2015) possible read and erase eeprom on OBD and in that case you don't need soldering wires and Jtag - BDM
On older model 2010-2013 first you must read eprom and flash on OBD and after that disabled DDM / PDM soldering wires like in user manual change reading in UART mode erase Eprom and Flash and than load flash (before reading on OBD ) and write with Jtag. Eprom is blank or erased but when you put back on car new km is in PDM / DDM
Job is done ☺
From my experience
Last edited by cokolo; 18th August, 2015 at 09:58 AM. Reason: UART mode not SPI my fault,sorry
teerak2uk (17th August, 2015)
Thank you. Now i must ask some more silly questions, i hope you can answer this for me or someone else on this forum. I am grateful.
"Firsr read dashboard eprom and make backup" -Is this done by OBD? How do i make backup of eeprom?
"Read on OBD PDM / DDM eeprom and flash " - How do I flash? :$
Thank you. I am totally new on this.
xanova (17th August, 2015)
When I have connected the Jtag wires to the DDM/PDM board. What should I do then? I do it in multiprog..
In Multiprog (like on picture) read Flash and Data flash .
I am very thankful for your reply. But I must say i am totally new. I will read the KM in DDM/PDM by UHDS. If there is KM stored there then i have to do DDM/PDM by jtag.
Should i use "read flash"/"Write flash" in the UHDS software by Smok? What happens then, what does "Read flash"? I do this by OBD? I would really love someone to have on Skype that can talk via voice with me.. .
you must enter in select car tab... then check pdm or ddm table
Bookmarks