I need a bit of help on this gearbox ecu - on Peugeot 508 - 2012
I need to read software inside ST10F280 to transfer the data to an old ecu gearbox
Original somebody change the clutch and forgot to connect engine Ground cable - after that the gearbox ecu is not communicating anymore
I have another ECU from a Citroen C4 same gearbox ecu but older software version
ORIGINAL IS : CFC310P.01
SECOND IS : CFC300
Difference between them is most likely software - I have tried to program the CFC300 on the car but i am unable to start the engine when diagnostic is asking because i have fault code in engine ecu related to Incorrect signal received from Gearbox
IF somebody read one before i would appreciate a bit of help.
Thanks in advantage
Bookmarks