dtc remove simos 9.1

**kospoz** · 10th October, 2015, 01:29 PM

Hello everybody i read this ecu simos 9.1 with Kessv2 in 40 seconds i think the file is ok.Can someone remove two faults? 16524 P0140, 16520 P0136.
The sensor has been replaced with oem the wiring is fine but the fault is here.
Thank you

**bobolin4o** · 10th October, 2015, 01:41 PM

Is this full file?
I think is partial read... for erasing DTCs, you need to have full.
Regards!

**kospoz** · 10th October, 2015, 01:46 PM

Originally Posted by bobolin4o

Is this full file?
I think is partial read... for erasing DTCs, you need to have full.
Regards!

And how can i read the full file?Maybe galletto can?

**bobolin4o** · 10th October, 2015, 01:49 PM

look, i'm not 100% sure about this...
Wait a while for someone else.
But if i'm right, that must be a full read, you can read full in boot mode.
Regards!

**mihaiservice** · 10th October, 2015, 01:53 PM

Hi
file are full read 100%

**kospoz** · 10th October, 2015, 01:55 PM

Originally Posted by mihaiservice

Hi
file are full read 100%

can you delete the codes?

**bobolin4o** · 10th October, 2015, 01:59 PM

Originally Posted by mihaiservice

Hi
file are full read 100%

Hm... and why is so empty...
Here is file from a Simos 3 for example, readed with programmer.
Maybe the Germans made Simos 9.1 with "compressed" software...
Regards!

**kospoz** · 10th October, 2015, 02:09 PM

strange....

**kospoz** · 10th October, 2015, 07:02 PM

tomorrow I will read it by bootmode with galletto and I will upload the file

**kospoz** · 11th October, 2015, 11:33 AM

here is with bootmode bobolin4o had right is different can somebody now help?

**bobolin4o** · 12th October, 2015, 06:54 AM

Originally Posted by kospoz

here is with bootmode bobolin4o had right is different can somebody now help?

First of all - never touched such ECU...
Here is the file, i think is good, but who knows... If you want to try it, flash it in boot mode!

**kospoz** · 12th October, 2015, 05:27 PM

Originally Posted by bobolin4o

First of all - never touched such ECU...
Here is the file, i think is good, but who knows... If you want to try it, flash it in boot mode!

The file is working good. bobo you have right about the fault 0000 but the mill is off no problem thanks again

**bobolin4o** · 12th October, 2015, 05:31 PM

Not so bad for first shot, yeah...
Thanks for the report!
Cheers!

**tomtom0785** · 19th May, 2016, 02:24 PM

29F400B_ExtFlash.rarhello - MAybe someone can help me here,....

i got stuck when trying to deacitvate the 2 fault codes
fault table is from adress 522D6 - 53245

no matter what i try - i cannot deactivate any fault code ( set to Zero or FF doesn't success )

original file is attached

thanks in advance
regards Tom