good day to all of you
My FVDI 2018 just stopped working today. it wont pick up on any usb port. i dont see any thing in the device manager.
i tried on 3 diffrent pc's. it was working good for about 1 year now.
any ideas on what could be the problem?
Have you tried with a different usb cable? also check the voltage on the usb cable if it is working. If its windows related, i can try assist over Teamviewer.
USB.jpg
Fvdi 2014
Everytime i start up vag V18.0 with keyreader attached, the program shuts off.
Vag 21.0 starts fine with keyreader attached, here the MM7 tool does work proper.
I run it on W7 32 and windows xp, no virus scan.
Does anyone have the same problem, and a solution.
I am considering buying a 2018 Fvdi with vag V18.0 and V24.o
rob h (20th January, 2019)
goo inside this folder and remove tag and post result
C:\Program Files (x86)\Abrites Commander Software List\Common\TagKeyTool
C:\Program Files (x86)\Abrites Commander Software List\Common\Tag
Professional bmw key service cas 3/3+ 4/4+ repair = reset ews egs 8hp = 6hp-egs19d
rob h (20th January, 2019)
Hi, first run AVDI rep. and then Fvdi.
Press Thanks and Reputation
rob h (20th January, 2019)
Perfect, thanks guys,
I could not get the avdi rep to work.
Have to check that out.
So i removed the tag and tagkeytool from c folder.
And it is fine now.
Thank you very very much guys,
Last edited by rob h; 20th January, 2019 at 06:42 PM.
Hi Guys
I have been struggling for a few weeks with Audi A4 BCM2 key writing and still have not managed to find a solution as of yet. I use V18 as (V24 does not work on BCM2 it fails on decrypting), then passes reading transponder. When i get to prepare dealer key in V18, it fails at about 98% writing the key. The key is blank and is PCF7945AC 868Mhz and is a generic. I have soldered on a 501pcf, which improved reading keys all round. An original key reads perfectly, in the casing in Tag Tool. The generic i have to take out of the casing and basically hold the antenna right on the chip to actually read it. Could it be a dud key?
I am considering purchasing KD-x2 as apposed to Tango or VVDI key tool as it looks like it has better growth - Any advise? Also would i need Orange 5 to dump the BCM2 as FVDI cannot BCM2 dump. Also IMMO5 does not work with VVDI2 1.2
vvdi prog where to buy better on eBay or official website http://www.vvdishop.com/ and what's the difference?
how much have I watched the same prices
thanks
hey there , is it normal that fvdi cant get ride of my cp protection after i read eeprom 25640 on getaway by upa usb it says dump is from another module ??
waaauw flashed my getaway with vcp read it again with upa , started the procedure again with fvdi and it worked ... i got it on video it said succes with removing protection so i looked up to the dash and it was stil in safe mode ... what a waste of money and time
Bookmarks