any help????
dear friends i have trouble with dq200 board i have to read dump and write another one but my clone kess has option on extras but when i click it, Ok button dissappears, software version is 2.08.
i have also ktag and galletto clone , ktag doesnt have on list and i dont check galletto yet.
also i built cable schema from internet but i want to know there have to be resistor on can lines or not?
i also tried an software which works with elm based devices and its not connecting too.
1- whats wrong with my kess ?
2 - which schema is true for dq200?
3-Can i change software with clone vas 5054a?
b.regards
Sent from my iPhone using Tapatalk
Last edited by erdilmen; 17th December, 2015 at 10:24 AM.
any help????
1. Ktag don't coverage OBD programming and module
3. Yes you can update orginal firmware by OBD with any VAS
All brand FileService - Custom - remapping company
POWER>DPF>EGR>KL>SCR>TVA>DTC's>Lambda>NOx>CustomSp ecialization -
| Diesel | Bosch/Siemens SID/Denso/Delphi/Visteon/Phoenix
Mantulis (29th December, 2015)
Bookmarks