send ecu number,find ori flash and writte with willem
Mercedes sprinter edc15c6 2003
used a clone galletto v54 to remap, it read it ok,
I altered the file and wrote it back to the vehicle. now it wont start.
I think maybe it was the wrong checksum??
it wont let me read or write it now, error message seedkey,
when I ID it all that comes up is 5vg
I have took the ecu off opened it up and desoldered the chip am29f800bt and flashed it with a willem programmer
hooked it up on the bench but I am still getting the error message seedkey.
can any one tell me what I have done wrong??? is there anything else that I have to do??
any ideas would be greatfully appreciated.
thanks.
send ecu number,find ori flash and writte with willem
hi mercis,
I have done this already but still the same.
75vG.
0281010921
1037351776
CR2/C95
2.2l
8FM04B121
S00C95
Last edited by ed209trucks; 15th January, 2016 at 10:14 PM.
Do you have "Start Error" ?
If YES, read Immo Box HC08 and ECU 5P08.
Last edited by waldi1979; 15th January, 2016 at 11:11 PM.
it is the old dash, I have on the edc light and the glow plug light.
As far as I remember this text is displayed instead of mileage.
no the mileage is still shown
can the ssedkey be located in the original file from the ecu??
you can use immo emulator cr1 and car work whitout any error
you can also try another ecu just swap eeprom or right your original file from your backup with boot mode maybe with obd your tool isnt enough good
problen is not ecu. clone galletto can derstroy eeprom that is reason why car no start
Antonio! Muches Gracia's you real Help Me!!!! Flash file is stock?
Just check 100% stock
Bookmarks